-----------------------------------
Waynder
Thu Oct 23, 2008 11:49 pm


-----------------------------------
brum brake does not use hydroulics it uses cable lines... wire...


so you do this...

make a peg that will be used for foot brake...

now you need to connect foot brake and hand brake with rear drum...   so you can use both brakes same time... to do that you need to use Y connector...


so... cable goes from rear drum to Y connector... one part goes to foot brake.. other to hand brake...

FOr Y connector you can use the one piaggio uses to connecto throttle with carburator and oil pump... heres picture...

http://www.easyparts.nl/showdrawing_popup.php3?grouppath=0-968-1-m412-m167-m460-m384-s1490-d31391&brandid=1&modelid=384&submodelindex=ar_gc&drawingid=31391

that cable under NUMBER 3... this is drawing from Aprilia so its rather expensive..around 30€... but from piaggio (engine like gilera sp, typhoon big bore , old skupper) its a lot cheaper...


but... cuz its all in cables... YOU CANT USE BOTH HAND NAD FOOT BRAKE AT SAME TIME:.. i



hope i helped...