Ok so i had Renthal bars on my runner before, using a doppler stem.

But i took it off because it was loose.

I see most people using the TNT stem's so i ordered one of those instead.

http://scooter-center.com/catalog/product_info.php?cPath=4_13_164_1063&products_id=7131

Even when i tighten it up fully, it still comes loose when i push the bars hard against lock.

Any ideas?

Also i ordered these bars, and my fucking throttle assembly doesn't fit over the bars =(


http://scooter-center.com/catalog/product_info.php?products_id=5396&cPath=5_52_314_4318

well... tnt is made or tnt handlebar... renthasl is mostly for bikes so i gfueess it has different diameter...

why not trying to put something on the place where you tight stem to bar... some thin aluminium thingy... some sort of spacer...

Tried that too but didn't have much luck with it.

It has the system with the bolt inside the stem, where the two seperate pieces of stem slide apart and push against the inside of the fork tube.

I thought everybody used these stems and that it will work?


For the throttle, i could try to grind away 1mm of metal so it fits on the bar properly.