i have problem with 45°polini manifold on my zip, when i put it on scoot, it wont start, than i put gasoline in cylinder directly and the minimum gas is so strong that it starts going without throttle, between block and manifold i have made, i think it's called gasket i'm not sure, so air doesn't come in, everything is how it soul be,

setup is:
malossi sport
mf power-i have tp nardo, just have to put it
carb. dell'orto 19bs, main jet 80,
open air filter top performance

and when you switch back to normal mainfold its oke?

Waynder wrote (View Post): › and when you switch back to normal mainfold its oke?

yes, i tried to do something with that little screw for minimum gas but nothing, it was the same when i would put this manifold on my nrg, i though it was because of gasket, than i put the gasket sealer and it same, the manifold is like new

I am gona use this topic to ask you guys:

tell me something,I have to buy the 45 mainfold,but the shit is very expensive,60€ for a piece of rubber...so is there any other option to modify the originial mainfold or i will have to buy the new one

just cut it

thats what most of us do

just cut it,and than... just mount it back on what is left of the original mainfold???

Waynder wrote (View Post): › just cut it thats what most of us do

Are you joking?

no lol... got them here... works like a charm... but i dont use it... i have original one.. but my tank is modded so it works good on twelve...

runner got the tank in front,so it shouldnt be a problem, but the scoot is shoting down anyway,so I think I have to put on the 45 mainfold

do you have any pics of yours cuted mainfold?